Another question. I have a DCS200 bought as a complete outfit, which came with an N8008s body. It works fine. I have three DCS200 backs, bought on eBay some time ago for very little, that work fine but have no camera bodies. The other day, I bought a couple of N8008 bodies very inexpensively. The 200s recognize that there is a body attached, the body however does not seem to recognize that it is attached to the 200. Continues to say it is empty and the shutter will not fire. I could have sworn I had seen or heard of DCS200 backs with N8008 (not N8008s) bodies. The manual downloaded from Kodak, however, only refers to N8008s.
Anyone seen a DCS200 working on an N8008, or know for sure that it cannot work?
Thanks,
Ross
Can DCS 200 work with N8008 body?
-
- Posts: 105
- Joined: Tue May 16, 2006 1:10 pm
- Location: Australia
- Contact:
-
- Posts: 97
- Joined: Fri Nov 03, 2006 10:34 am
- antispam: No
- Location: England
I have the same experience-I only have a N8008 and it wont do anything on my 200 (thinks it's empty, wont fire.)
Jonathan
Jonathan
DCS serial no. survey
RC-760, EOS-1D & Ds Mk I, II, III, EOS*DCS-3, 5, DCS, DCS-200ci, 420, 460, D1, D1H & X, D2H & X, E2, F, F2, F3, F4, MVC-2000, 5000, 7000, RD-175, 3000, EF 50mm f/1.0, Audi S2, Porsche 911, GSX-R1000 K9
RC-760, EOS-1D & Ds Mk I, II, III, EOS*DCS-3, 5, DCS, DCS-200ci, 420, 460, D1, D1H & X, D2H & X, E2, F, F2, F3, F4, MVC-2000, 5000, 7000, RD-175, 3000, EF 50mm f/1.0, Audi S2, Porsche 911, GSX-R1000 K9
DSC backs on a F801/s or N8008/s
Hi, I think you should remove the little pin/screw on top of the film rails - just under the viewfinder - at the back of your camera. Than the back will work. Let me know if it works.
Regards,
Nico
Regards,
Nico
D1/D1X/D1H/D2H/D2X etc.